1992 - 1995 Acura Integra ECU Connector Pinout
From AllPinouts
Connector pinout for: 1992 - 1995 Acura Integra ECU
The ECU - Electronic Control Unit is an embedded system that controls one or more of the electrical systems or subsystems in a vehicle.
ECU - Electronic Control Unit Connector.
Connector A
| Pin | name | Signal |
|---|---|---|
| A4 | VTEC Solenoid Valve | Analog |
| A21 | Ignition Control Module | RPM |
| A24 | Power Ground | Ground |
Connector B
| Pin | name | Signal |
|---|---|---|
| B10 | Vehicle Speed Sensor | Speed |
Connector D
| Pin | name | Signal |
|---|---|---|
| D1 | Voltage Back Up | Power |
| D2 | Brake Switch | Analog |
| D6 | VTEC Pressure Switch | Analog |
| D11 | Throttle Position Sensor | Analog |
| D13 | Engine Coolant Temperature Sensor | Analog |
| D14 | Primary O2 Sensor | Analog |
| D15 | Intake Air Temperature Sensor | Analog |
| D17 | MAP Sensor | Analog 0.32V @ -13.9 PSI 4.84V @ 10.94 PSI |
Notes
References
Something left uncovered? You are welcome to add information, explanations and fix errors, simply by clicking the edit link that appears on top of this page. There is no need to worry about accidentally damaging AllPinouts when adding or improving information, as other editors are always around to advise or correct obvious errors, and AllPinouts's software, known as MediaWiki, is carefully designed to allow easy reversal of editorial mistakes.
