Apple iPod jack Connector Pinout
From AllPinouts
Connector pinout for: Apple iPod jack
Contents |
2nd generation iPod
2nd generation iPod jack connector - 6 pin 4 pole 1/8 inch plug + 2 rings iPod (at cable side)
| Pin | Signal | Color |
|---|---|---|
| 1 | Audio left | black |
| 2 | Audio right | white |
| 3 | Audio ground (GND) | red |
| 4 | Serial RxD | green |
| 5 | +3.3V Power to Remote | blue |
| 6 | Digital ground (GND) | yellow |
3rd generation iPod
3rd generation iPod jack connector - 8 pin 4 pole plug + 4 pin (at cable side)
| Pin | Signal | Color |
|---|---|---|
| 1 | Audio left | black |
| 2 | Audio right | white |
| 3 | Audio ground (GND) | red |
| 4 | Sleeve - Video Out on iPod Photo and 5th generation iPod | |
| 5 | Serial RxD | green |
| 6 | Serial TxD | |
| 7 | Digital ground (GND) | yellow |
| 8 | +3.3V Power to Remote | blue |
Notes
- Serial signals are not directly compatible with RS232 levels, you have to use a RS232-TTL converter such as the MAX3232E chip.
- On the 3rd generation iPod the remote control data is sent via a serial Apple Accessory Protocol.
References
Something left uncovered? You are welcome to add information, explanations and fix errors, simply by clicking the edit link that appears on top of this page. There is no need to worry about accidentally damaging AllPinouts when adding or improving information, as other editors are always around to advise or correct obvious errors, and AllPinouts's software, known as MediaWiki, is carefully designed to allow easy reversal of editorial mistakes.
